Synergistic stabilization of Pickering emulsions by a mixture of surfactants and colloidal particles has received increasing interest in recent years but only a few of them can produce high internal phase double emulsions (HIPDEs) with good stability. In this study, we present a feasible and common method of preparing Pickering high internal phase emulsions (HIPEs) with tunable inner morphology costabilized by a biosurfactant lecithin and silica nanoparticles. We investigate the influence of the pH value on the interfacial behavior of lecithin and elucidate the synergistic mechanism between lecithin and silica nanoparticles in different conditions in the stability of as-prepared emulsions. Specifically, water-in-oil (W/O) Pickering HIPEs can be successfully stabilized by lecithin and hydrophobic silica nanoparticles in a wide pH range (pH 1-10), while catastrophic phase inversion occurred at high pH values (pH ? 11). Interestingly, stable water-in-oil-in-water (W/O/W) high internal phase double emulsions (HIPDEs) can also be prepared via a two-step method by the cooperation of lecithin and silica nanoparticles. Moreover, functional interconnected porous monoliths and microspheres are facilely fabricated by emulsion templates and their potential applications are explored.Terpenoids are an important class of secondary metabolites that play an important role in food, agriculture, and other fields. Microorganisms are rapidly emerging as a promising source for the production of terpenoids. As an oleaginous yeast, Yarrowia lipolytica contains a high lipid content which indicates that it must produce high amounts of acetyl-CoA, a necessary precursor for the biosynthesis of terpenoids. Y. lipolytica has a complete eukaryotic mevalonic acid (MVA) pathway but it has not yet seen commercial use due to its low productivity. Several metabolic engineering strategies have been developed to improve the terpenoids production of Y. lipolytica, including developing the orthogonal pathway for terpenoid synthesis, increasing the catalytic efficiency of terpenoids synthases, enhancing the supply of acetyl-CoA and NADPH, expressing rate-limiting genes, and modifying the branched pathway. Moreover, most of the acetyl-CoA is used to produce lipid, so it is an effective strategy to strike a balance of precursor distribution by rewiring the lipid biosynthesis pathway. Lastly, the latest developed non-homologous end-joining strategy for improving terpenoid production is introduced. This review summarizes the status and metabolic engineering strategies of terpenoids biosynthesis in Y. lipolytica and proposes new insights to move the field forward.Natural and abundant plant triterpenoids are attractive starting materials for the synthesis of conformationally rigid and chiral building blocks for functional soft materials. Here, we report the rational design of three oleanolic acid-triazole-spermine conjugates, containing either one or two spermine units in the target molecules, using the Cu(I)-catalyzed Huisgen 1,3-dipolar cycloaddition reaction. The resulting amphiphile-like molecules 2 and 3, bearing just one spermine unit in the respective molecules, self-assemble into highly entangled fibrous networks leading to gelation at a concentration as low as 0.5% in alcoholic solvents. Using step-strain rheological measurements, we show rapid self-recovery (up to 96% of the initial storage modulus) and sol ⇔ gel transition under several cycles. Interestingly, rheological flow curves reveal the thixotropic behavior of the gels. To the best of our knowledge, this kind of behavior was not shown in the literature before, neither for a triterpenoid nor for its derivatives. Conjugate 4, having a bolaamphiphile-like structure, was found to be a nongelator. Our results indicate that the position and number of spermine units alter the gelation properties, gel strength, and their self-assembly behavior. Preliminary cytotoxicity studies of the target compounds 2-4 in four human cancer cell lines suggest that the position and number of spermine units affect the biological activity. https://www.selleckchem.com/peptide/avexitide.html Our results also encourage exploring other triterpenoids and their derivatives as sustainable, renewable, and biologically active building blocks for multifunctional soft organic nanomaterials.The mechanism of the noncatalytic bromination of carboranes was studied experimentally and theoretically. We found that the reactions of o- and m-carboranes 1 and 2 with elemental bromine are first order in the substrate but unusually high (approximately fifth) order in bromine. The calculated energy barriers of these reactions decrease sharply as more bromine molecules are added to the quantum-chemical system. A considerable primary deuterium kinetic isotope effect for the bromination of 2 indicates that the rate-limiting stage is B-H bond breakage. According to quantum-chemical reaction path calculations, the bond breakage proceeds after the intrusion of a bromine atom into the B-H σ-bond. The 9-Br and 9-OH substituents in carborane 1 strongly retard the bromination of the corresponding derivatives. The bromination mechanism of 9-OH-1 is complex and includes neutral, deprotonated, and protonated forms of the carborane. The high experimental kinetic reaction order in bromine, together with quantum chemical modeling, points to a specific mechanism of bromination facilitated by anionic bromine clusters which significantly stabilize the transition state.Gas aggregation and formation of interfacial nanobubbles (INBs) provide challenges and opportunities in the operation of micro-/nanofluidic devices. In the current study, we used molecular dynamics(MD) simulations to investigate the effects of hydrophobicity and various homogeneous surface conditions on gas aggregation and INB stability with a series of 3D argon-water-solid and water-solid systems. Among various signatures of surface hydrophobicity, the potential of mean force (PMF) minima exhibited the strongest correlation with the water molecular orientation at the liquid-solid interface, compared to the depletion layer width and the droplet contact angle. Our results indicated that argon aggregation on the substrate was a function of hydrophobicity as well as competition between gas-solid and water-solid PMFs. Thus, one precondition for gas aggregation on a surface is that the free energy minima of gas induced by the surface be much lower than that induced by water. We found that although the presence of gas molecules had little effect on the measures of wettability, it enhanced density fluctuations near liquid-solid interfaces.